![]() (2).Although some parts have grease fittings, other parts are factory sealed, but do not affect the fit and quality of the parts. ![]() (1).Please check the Compatible Fitment Chart above before payment making sure all the suspension parts listed on this page are compatible with your automobile. This makes it easier to correctly tighten the control arm fixing screws. However, replacing bearings, control arm bushings and ball joints can be very complex and costly.ġ.First lift the vehicle using a car lift, ideally a wheel-free four-post car lift. Tip:If the control arm is in working order, it is possible to only replace the defective bearings and joints. (3).Increasingly woolly and imprecise steering. (1).Noise (squeaking, creaking, rumbling). A defective control arm can manifest in the following ways Otherwise single rust particles can enter the new control arm joint via the ball pin, potentially leading to premature failure of the joint.ĩ.Fit the new control arm with the supplied accessories and attach new fixing screws and nuts.ġ0.Reattach the stabilizer and, if applicable, the leveling sensor for headlight leveling to the control arm. a puller).Ĩ.Clean the mounting flange of the ball joint pin on the steering knuckle with sandpaper and then with brake cleaner. a transmission lifter.Ģ.Treat the fixing screws and nuts of the control arm with rust solvent and leave it to work for a few minutes so that they are easier to loosen.ģ.On vehicles with automatic headlight levelling, it may be necessary to detach the leveling sensor from the control arm.Ĥ.If the stabilizer is connected to the control arm, the next step is to loosen and remove the corresponding stabiliser fixing screws.ĥ.Loosen and remove the control arm fixing screws.Ħ.Loosen the ball joint at the steering knuckle with a suitable special tool (e.g. Warning:Depending on the axle design, the control arm may need to be secured against falling with a suitable device, e.g. They also absorb lateral movements and forces resulting from driving off and braking. Therefore, they have a significant influence on the driving characteristics of the vehicle.Ī dynamic or a comfortable driving style? The control arms are individually adjusted to the vehicle depending on the desired characteristics. Suspension Control Arm Replacement GuidelineĬontrol arms are installed in pairs on the front and rear axle and connect the chassis to the wheels as part of the suspension. Superseded Part Number: suspension front lower control arm,replacing control arm.OE/OEM Part Number: control arm car,suspension arm,control arm ball joint.Type: Control Arm & Ball Joint Assembly.Placement on Vehicle: Front+Lower+Right+Left.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |